Get in

Strap in

The AutoBack

The AutoBack offers hands-free entry, automatically closing when the boot enters and opening when it's time to unstrap. It also folds flat for skating, chairlifts, and storage.

Fast Strap

The innovative long ankle ladder stays connected for fast, one-handed strapping, while the classic ratchet lets you fine-tune AnkleStrap tension.

The Locking Strap

Set it and forget it! The Locking Slap Ratchet and tri-toothed ladders keep the strap in place for quick entry and exit, with easy adjustments on the go.

Footbed

  1. To remove or mount the footbed, simply use a Phillips #2 screwdriver to remove the footbed screw.

  2. Take care not to pull or lift the footbed straight up as it slides into place via a track in the baseplate. Pulling up on the footbed might damage the sliding mechanism.

  3. To make micro size adjustments, choose one of the 3 holes for a custom fit.

Toe Straps

  1. To change toe straps/toe ladders, you’ll first need to remove the screw holding the footbed in place. Carefully slide the footbed out of the binding. 

  2. Then, remove all mounting screws from the disk to lift the binding off the board. 

  3. Finally, insert the toe ladders through the slot on the bottom of the baseplate. Use the toolless clip on the toe strap to connect strap to ladders.

Ankle Straps

  1. Simply unscrew the ankle mounting hardware with a Phillips #2 screwdriver & carefully set the loose hardware to the side.

  2. Use the same Phillips #2 to remove/replace the ankle straps from the ladders. 

  3. Mount the new ankle ladder onto the binding with ankle mounting hardware. 

Highback

  1. To make forward lean adjustments, first make sure the highback is disengaged from the hub.

  2. Then, spin the forward lean adjuster to the left to loosen. 

  3. Slide the forward lean adjuster up or down to achieve the desired highback position.